a Happy Griffin 4 éve
551
Még több ilyen
CISCO Stackwise
Multichassis EtherChannels (MEC)
Virtual Switching System (VSS)
Cross: PC <-> Router, Switch <-> Hub
Straight: Router <-> Switch, Router <-> Hub
Straight: PC <-> Switch, PC <-> Hub
Hub: TX3, TX6, RX1, RX2
Switch: TX3, TX6, RX1, RX2
Router: TX1, TX2, RX3, RX6
PC: TX1, TX2, RX3, RX6
Fiber
10GBase-LR Little Connector
1000Base-LX Single-Mode 5KM / Multi-Mode 550M
1000Base-SC Square Connector Multi-Mode 220M ~ 500M
Each Cable needs a GBIC or SFP
Fiber Cleaver
UTP
Cat-5 UTP 100Base-TX
Cat-5e UTP 100Base-TX
Cat-6a UTP 10GBase-TX
Cat-6 UTP 1000Base-TX
Excessive Collision
Late Collision
After 64 Bytes / 512 bits
Duplex Mismatch
Carrier Sense Multiple Access with Collision Detection.
N Collision Domain N Broadcast Domain
N Collision Domain 1 Broadcast Domain
1 Collision Domain 1 Broadcast Domain
Jimbo Frame MTU 9000 Bytes
Default MTU 1500 Bytes
Layer 2 Data -> Frame
Layer 3 Data -> Packet
Layer 4 Data -> Segment
1 to 7 - De-encapsulation
7 to 1 - Encapsulation
Total: 20 Bytes
Acknowledge Number
Sequence No
80 Bytes
Uses a lower transmission to ensure RELIABILITY
Transmit Packet as stream
Send Transmission in sequence
Telnet
POP3
SMTP
FTP
HTTP
Header
CheckSum
Length
Destination Port
Source Port
8 Bytes
Characteristics
Higher Transmission Rate to support latency-sensitive application
8 byte header
Transmits Packets Individually
Protocol
VoIP
DNS
DHCP
Source & Destination IP Address
QoS
Header: 20 Bytes
1 Physical
2 Data Link
Data 48-1500 Bytes
Type/Length 2 bytes
SA MAC 8 Bytes
DA MAC 8 Bytes
Premable 8 Bytes
FCS 4 Bytes
Encapsulated to become FRAME
3 Network
Encapsulated with IP
Encapsulatd to become PACKET
4 Transport
Encapsulated with TCP/UDP
Subtopic
Encapsulated to become SEGMENT
5 Session
6 Presentation
7 Application