connection of metals

Mais informações

Epithelial Tissue

por heyo H

THE VOLCANOES

por Gabriela Sanchis

Properties of Materials

por Neil Turner

Transfer of Thermal Energy

por farahridha ameerulshaun

connection of metals

riveting

Threaded

For connecting parts with thin walls (up to 0.3 mm). They differ in that the inner part has a threaded thread, the outer one has a vertical notch that prevents rotation around its axis. A screw is twisted inside, pulling the free part of the housing to the junction. This is how it turns out — due to crumpling — the closing head.

Pistons

They are used for low-load connections, they are made mainly of soft metals (aluminum and alloys, copper).

Semi - tubular

They require less effort during installation, but they also have low strength. They are used in connections with a small mechanical load.

soldering

Radiation method

The radiation type of soldering is produced due to a powerful luminous flux, which is formed by a quartz lamp, a laser or a cathode defocused beam.

Diffusion

The solder inside the seam zone is kept at a certain temperature longer than, say, with conventional capillary soldering. The connection of the two blanks occurs due to the diffusion of solder and soldered metals.

Capillary

The solder is melted, it heats up and fills the space between the two prepared parts. The wetting of the surface of the parts and the retention of the solder is largely due to the effect of capillarity.

welding

Diffusion welding

+ to combine homogeneous and heterogeneous solids; + avoid deformation of parts; + do not use consumables in the form of solders and fluxes; + get waste-free production; + receive any area of the contact connection zone, limited only by the possibility of equipment; + ensure reliable electrical contact - the need to use specific expensive equipment; - the requirement to have special knowledge, skills and understanding of the work process; - time spent on thorough pre-processing of workpieces; - the difficulty of checking the quality of the seam without the need for its destruction.

Thermal

Muffle

Crucible

+ excellent joint strength indicators. + low labor intensity of work. + low cost. + minimum metal consumption. - irregularities on the surface of the workpiece and the presence of an oxide film significantly impairs the quality of the joint. - thermal welding is possible only with metals that are close in terms of refractoriness

Arc welding

Automatic

Mechanized

Manual

Advantages and disadvantages

+ does not require complex training; + high process performance; + low cost of consumables (welding electrodes); + the simplicity of the process makes it easy to automate and mechanize it; + a small area of surface heating. - binding to the power grid; - inability to work without current converters (rectifiers, inverters) and transformers; - the presence of a preliminary stage of preparation of the welded surfaces.